Standard model method

Standard model method 

 According to the drawing wedm in advance in processing a standard model or the qualified stamping parts, to adjust the assembly put it in

between convex, concave die, upper and lower die relative motion can be reasonable degree when appropriate.

 Measurement method

  Measuring method of the measuring tool have feeler. Precision stamping parts A feeler method after the adjustment convex, concave die clearance good uniformity, it is the commonly used method. Assembly, the punch in the concave die in the hole, convex, concave die according to the size of the clearance choose different specifications of the feeler insert convex, concave die  clearance, inspection concave die around the blade gap everywhere, and according to the measured results adjustment. If the adjustment of the punch fixed board knock until adjust good so far. 

 Adjustment method of repair match means

 Die in use after period of time, because the convex, concave die normal wear and tear. To working parts inspection, if products produce burr, convex, Precision stamping parts concave die dull and collapse the blade factors, it is because of the convex, concave die clearance for wear changed, namely bigger or not even. To make the convex, concave die restored to the original gap value out of parts can use the following method to qualified for repair match means.

Convex, concave die clearance greaten repair match means method 

 General dies in use after period of time, because normal wear will make convex, concave die gap increase gradually, thus to make the work and so on a series of problems produced burr. This kind of circumstance, can use first thickness is equal to one of the KuaiGui insert gap between the convex, concave die, if convex, concave die clearance does not too big, the grinding work part of the blade continue to use, can improve the quality of stamping. When gap value too big when, the recoverable high temperature heat of local forging the modification methods female die size make it restored to the original gap value. Workpiece cooling followed by the pressure seal the law to file to trim gap value, and with the flame hardening method to improve the blade surface hardness. 

 Convex, concave die clearance does not even repair match means method 

Dies after a period of using, clearance does not even can make blunt a local produce burr or the blade was edge chewed. In normal wear punching die, because after wearing precision guide device that reduce convex, concave die happen relatively migration, respectively in the guide pin and a guide to cover on the plating chromium layer the restored to its original size, Precision stamping partsagain through the pressure seal the law will remove file high. If it is due to the pins loosening lose positioning function and cause different convex, concave die heart, and cause convex, concave die clearance does not even. Should first will convex, concave die gap adjusting well, to match for taper pin.