Folder specific design

Folder specific design 

 To improve the milling fixture installed in the machine tool stability, Precision CNC machining parts  reduce its intermittent cutting may be caused by vibration, not only in the specific folder have sufficient stiffness and strength, their height and width ratio should also beappropriate, a general H / B ≤ 1 ~ 1.25, in order to reduce the fixture center of gravity, so that as close as possible to the workpiece surface countertops.

Precision CNC machining parts In addition, we must set a reasonable and ear blocks to strengthen the tendons.   If the folder specific wide, can be set up in the same side of two T-slot milling machine table equidistant between the ears Block; of heavy-duty milling fixtures, specific folders should also be set up at both ends of the rings, such as lifting holes or to carry.   In the milling process, the often installed in the milling fixture table, together with the jig with the workpiece feed table for movement.In the milling process, the often installed in the milling fixture table, together with the jig with the workpiece feed table for movement. According to the workpiece feed means of general milling fixture can be divided into the following two types:    

  1. Linear feed-type milling fixture 。In the milling process, the often installed in the milling fixture table, together with the jig with the workpiece feed table for movement.

2. Circle feed milling fixture.Such fixtures are commonly used in the milling machine with rotary table, the workpiece table, together with the fixture with the continuous, slow movement of the rotary feed, no parking will be loading and unloading the workpiece. According to the processing requirements of the two cutter head can also be rough at the same time, finishing  

  Precision CNC machining parts Milling is a flat, keyway, gear and a variety of forming surface processing methods commonly used. Processing the workpiece in the milling machine, the general adoption of the following types of clamping methods:   

   (1) directly in the milling machine table clamping a large workpiece clamping often directly in the table, with stud, plate compactor, which need to dial indicator methods, tools such as zoned to find the needle surface and the cutter is processing relative position.      

 (2) vice flat tool used for clamping the workpiece in the shape of a simple, small parts, general machine tools can be used in clamping vice in the mouth, the need to ensure that when used in machine vice the correct position.

  (3) dividing head with the workpiece clamping, the need for indexing of the workpiece, the general direct clamping head in the sub-degrees. In addition, indexing of the workpiece without dividing head with clamping processing is also very convenient.

 (4) with V-shaped frame workpiece clamping method is generally applicable to.